TH-D72A/D72E
2
Document Copyrights
Copyright 2010 by Kenwood Corporation. All rights re-
served.
No part of this manual may be reproduced, translated,
distributed, or transmitted in any form or by any means,
electronic, mechanical, photocopying, recording, or other-
wise, for any purpose without the prior written permission
of Kenwood.
Disclaimer
While every precaution has been taken in the preparation
of this manual, Kenwood assumes no responsibility for er-
rors or omissions. Neither is any liability assumed for dam-
ages resulting from the use of the information contained
herein. Kenwood reserves the right to make changes to any
products herein at any time for improvement purposes.
1. How to Remove the Case Assembly
from the Chassis
1. Remove 2 screws
q
.
2. Remove 2 knobs
w
.
3. Remove the SP/MIC jack cover
e
.
4. Remove the front panel from the chassis.
2. How to Remove the PCB
2-1. Control PCB (TX-RX A/3)
1. Remove the packing (CHASSIS)
r
.
2. Remove 1 screw
t
then lift the SP holder and remove
the FPC
y
,
u
.
3. Remove 5 screws
i
,
o
and remove the packing (SP/
MIC)
!0
.
4. Lift the control PCB and remove the FPC
!1
,
!2
from TX-
RX PCB.
2-2. RF PCB (TX-RX C/3)
5. Remove the top panel
!3
from the chassis.
6. Remove the solder of the earth spring
!4
and lift.
Note:
After TX-RX PCB is fi xed to the chassis with the
screws, the earth spring is installed.
7. Remove 10 screws
!5
,
!6
, and 3 round screw
!7
.
8. Lift the TX-RX PCB.
DISASSEMBLY FOR REPAIR
(X57-784)
(A/3)
CN715
CN719
(X57-784)
(A/3)
(X57-784)
(C/3)
@
@
.
;
=
=
8
2
8
B
B
>
>
8
:
: