Keith McMillen Instruments K-MIX, Руководство пользователя

Страница: 78 / 156

K-M
IX
H
ARDWARE
67
4.2.17 – T
RIM
The [TRIM] button is used to enter K-Mix’s “Trim Mode” — here you can adjust the input trim
levels for input channels 1–8.
4.2.17.1 – W
HAT
D
O
T
HE
C
ONTROLS
D
O
?
F
ADER
B
EHAVIOR
In Trim Mode, faders 1–8 are used to control the amount of trim (or “gain”) to apply to input signals.
• Move a fader up to increase the trim level for that channel.
• Move a fader down to decrease the trim level for that channel.
The master fader is not used in Trim Mode; it will not respond to touch and its LEDs will be off.
R
OTARY
B
EHAVIOR
The rotaries are not used in Trims Mode; they will not respond to touch and their LEDs will be off.
C
HANNEL
S
ELECT
B
UTTON
B
EHAVIOR
The channel select buttons are not used in Trims Mode; they will not respond to touch and their
LEDs will be off.
4.2.17.2 – A
DJUSTING
T
RIM
L
EVELS
To adjust the input trim levels, do the following:
1. Press the [TRIM] button to enter Trim Mode.
2. Adjust faders 1–8 to set the trim level for each of the 8 input channels. Moving a fader up increases
the trim level, moving it down decreases the trim level.
Also note that input channels 1–2 have different trim ranges than input channels 3–8. The ranges are as
follows:
• Ch. 1–2 Trim Range: 0dB to +60dB
• Ch. 3–8 Trim Range: -20dB to +40dB
4.2.17.3 – [SHIFT] F
UNCTIONALITY
The [SHIFT] button does not perform any special functions when in Trim Mode.
4.2.18 – +48V
The [+48V] button is used to adjust K-Mix’s phantom power settings.
Similar to the [BYPS] button, the [+48V] button must be held down while performing any
adjustments.