![background image](http://html1.mh-extra.com/html/keiser/m3i-lite/m3i-lite_installation-and-operation-manual_3933847008.webp)
555518_A
p8.
M3i INDOOR GROUP CYCLE
OPERATION
3. Align the holes of the flywheel with the holes of the hub.
NOTE: The flywheel should be flush against the hub.
4. Install the hubcap:
a) Align the holes of the hubcap with the holes of the
flywheel, refer to Figure 4.
b) Hold the flywheel in position.
c) Use the five, M6x1x20 SS socket head cap screws
(supplied) and a 5mm Allen wrench and tighten
the screws.
d) Spin the flywheel to make sure the flywheel runs true
and straight (no wobbling).
5. Cover each cap screw with a clear decal (supplied).
1. Remove the two 6mm Allen screws and washers from
the base frame, refer to Figure 5. Do not discard the
screws. They will be used to mount the flywheel guard.
2. Place the open end of the flywheel guard over the
mounting stud located on the frame of the cycle, refer to
Figure 6.
3. Swing the guard over the flywheel, refer to Figure 7.
INSTALLING THE FLYWHEEL GUARD
Figure 4. Flywheel and Hubcab Installation
Figure 5. Remove 6mm Allen Screws
Figure 6. Flywheel Guard Placement
Figure 7. Center Flywheel Guard Over Flywheel
NOTE: When installing and centering the guard, never touch the flywheel with the guard.