![background image](http://html1.mh-extra.com/html/keiser/m3i-lite/m3i-lite_installation-and-operation-manual_3933847011.webp)
555518_A
p11.
M3i INDOOR GROUP CYCLE
OPERATION
4. Remove the four 6mm Allen screws from the
handlebar tube, located below the computer mount,
refer to Figure 15.
5. Attach the handlebar slide to the handlebar tube with
the four screws previously removed. Use a 6mm Allen
wrench to tighten screws. There should be no gap
between the handlebar slide and the handlebar tube,
refer to Figure 16.
6. Install the handlebars on the handlebar slide:
a) Disassemble the L-handle assembly. Use a 5mm
Allen wrench and remove the screw and washer to
remove the handle stud.
b) Fit the handle stud in the handlebar spacer, and
then attach the handlebars to the handlebar slide,
refer to Figure 17. Hand tighten the assembly.
c) Place the L-handle onto the handle stud. The
L-handle should point away from the cycle. Install the
screw and washer to secure the assembly,
refer to Figure 18.
7. Loosen the L-handle. Slide the handlebar back and
forth, making sure it can move freely on the handlebar
slide.
• Check to ensure that all hardware is tight and components are properly assembled.
• Polish the cycle with paste or spray wax and a clean cloth.
FINAL INSTALLATION
Figure 15. Remove the 6mm Screws From the Handlebar
Figure 17. Assemble Handlebar, Handle Stud, and the Handlebar Spacer
Figure 16. Attach the Bottom Slide to the Handlebar Tube
Figure 18. Install L-Handle and Secure with Screw and Washer