KEEWAY 500ATV, Руководство по обслуживанию

Страница: 75 / 218

6. Engine Removal;Inspection & Installation
6-13
good-ventilated place. (indoor when you start the engine, ensure exhaust forced to
use dangerous or outdoor. If (when two or more people who work together, to be
on the safe side, keep remind each other.
Caution
Replace the removed washer, o-rings, seals, locknuts, lock washers, steed pins,
for example, and the new version. (Check the sealing parts and the appropriate
action, regroup. (Check parts after the demolition, cleaning parts before
measurement. (Repair torque screw and torque wrench, clean oil or oil from
before. (tight repair threaded bolts, nuts and screw, then tighten according to
specified torque, from large to small, from the heart of the lateral side. (Use
special lubricants and sealants and grease. (Make sure all part of clean,
lubrication for restructuring they when specified. (The use of special tools
according to the service manual. (Place and shop disassemble parts for the
correct assembly respectively. (Use original parts or their equivalence since.
1. CVT part remove check
According to the list of instructions on the order
1
Hexagon flange bolts M6*32
11
Crankshaft clapboard
2 Left upper lid 12 The countersunk head screws M6*
3
Hexagon flange bolts M10*100
13
The partition of the drive shaft
4 Steps mat 14 Left box nakedness
5
Hexagon flange bolts M10*160
15
Under the partition of the drive sha
6
Steps mat
16
Hexagon flange bolts M6*16
7
CVT active wheel (see Z-01 CVT active w
split said Ming)
17 Archives show is
8 CVT leather belt 18 Hexagon flange bolts M6*32
9 CVT driven wheel 19 The starter
10
Hexagon flange bolts M6*18
6