Keba Kemro KeTop T10, Руководство по проектированию устройства

Страница: 16 / 91

2.3 Personnel safety instructions
WARNING!
Danger of personal injury due to electric shock!
●
Supply the device exclusively from power sources that have an extra low
voltage (e.g. SELV or PELV according to EN 61131-2)
●
When using a SELV power source it can become PELV by reason of the
module construction and the connectors (grounding!).
●
Protective low voltage circuits must always be installed safely insulated
separated from circuits with dangerous voltage.
CAUTION!
Danger of fire in case of component failure!
●
In final application, make sure that the 24 V DC power supply to the operator
panel is adequately fused! Therefore a fuse that complies with UL 248 and
is rated max. 0,5 A must be used.
WARNING!
●
For the right projecting of the Handheld Terminal the manufactorer must
enforce a hazard and risk analysis. The following safety aspects must be
considered:
●
Right cable length for limitation of workspace.
●
Is an emergency stop button necessary and permissible?
●
Is the safety category for the application sufficient?
●
From the operating place the operator must have a good view at the hazard
area.
●
The device may be operated in faultless condition only and the operating
instructions must be observed.
●
The operator must have a sufficient educational level and must know details
of intended use described in the user’s manual.
●
The safety advices in the following chapters must be considered absolutely.
●
Further informations to safety and EMC are included in the appendices.
2.4 Transport Conditions
To avoid damaging the KeTop during further or return transport, the following
transport conditions must be fulfilled:
●
Always use the original packaging for the transport.
●
The environmental conditions for the KeTop (see chapter "Technical Da-
ta") must also be fulfilled during transport.
Safety notes KeTop T10
© KEBA 2014
Project engineering manual V1.02 16