V.A.C.
ATS Operations and Maintenance Manual
18
6.0
DISPLAY/TOUCH PANEL REPLACEMENT
6.1
Remove the Front Housing.
6.2
Disconnect the battery.
6.3
Place the unit on its back on
a flat surface.
6.4
Disconnect the Touch Panel
ribbon cable from the top of
the Control Board.
6.5
Disconnect the Display
Ribbon Cable from the
bottom of the Control
Board. This is done by
pulling the locking tab on
the connector fully forward,
and withdrawing the lead.
6.6
Disconnect the Inverter lead on the right side of the control board.
6.7
Remove the 4 screws holding the display to the control board.
6.8
Remove the display.
6.9
Fit new display by reversing the above. Lock the display connector by
pressing the shroud fully into the connector.
NOTE:
The Display Touch Screen may require calibration after a new unit
has been fitted. Refer to the relevant Technical Bulletin for detailed
instructions.
7.0
CONTROLLER BOARD REPLACEMENT
7.1
Remove the Front
Housing.
7.2
Disconnect the
battery.
7.3
Remove the
Display/Touch Screen.
7.4
Disconnect the Tubing
from the top of the
Pump Manifold.
7.5
Disconnect the ribbon
cables, Pump and
Valve connectors from
the Control Board.
7.6
Remove the 4 spacers,
and remove the
control Board.
7.7
Fit the new board by
reversing the above.
NOTE:
The Unit will require Configuration after the Controller Board has
been replaced. Refer to the relevant Technical Bulletin for detailed
instructions.
6.5
6.6
6.4
6.7
7.6
7.5
7.4
RESTRICTED USE
Certain pages of this manual are designated
“Restricted Use Only.” Information contained on
those designated pages may be used solely to
facilitate the proper maintenance and repair of
KCI products identified herein. If these terms are
unacceptable, immediately remove those
designated pages and return them to KCI, Attn:
Legal Dept. Refer to qualified service personnel
who are authorized by KCI for proper
maintenance and repair
