KBL beautyShaper, Руководство по эксплуатации

Страница: 23 / 48

6. Start-up
Before switching on for the first time:
• Determine the presettings for the device in the
service menu.
• Check correct installation of fluorescent tubes. The
tube labeling must be visible, otherwise no effect
may be obtained.
• Store these Operating Instructions in a place that
allows for easy access at any time.
6.1 Operating modes
STANDBY MODE
The device is in an idle state, i.e. it is connected to
the mains but is currently not being used. The tubes
and the lamps are switched off. From the standby
mode, you can change over to the operating mode
or to the service mode.
OPERATING MODE
The tubes and the lamps are switched on and a
session is in progress. While the device is in operating
mode, the settings for the ongoing session can be
changed via the interior control panel.
SERVICE MODE
In the service mode, the device is configured for the
operating mode. Various values can be displayed and
test functions can be carried out.
FAN RUN-ON
After the session, the fan runs on for 3 minutes in
order to cool down the device. The fan power is
automatically decreased as the tubes cool down.
O p e r a t i n g I n s t r u c t i o n s | KBL Tower beautyShaper
23