KBL 4800 alpha, Руководство по эксплуатации

Страница: 9 / 60

O p e r a t i n g I n s t r u c t i o n s | KBL 4800 alpha
9
SALTY AIR - CONTAMINATED AIR
Salty air, contaminated air may lead to
corrosion of the housing and electrical
components.
Damage to the tanning
device possible!
• Do not operate the tanning device in
locations with aggressive environmental
conditions (e.g. air containing chlorine).
• Do not install the tanning device at swim-
ming pools.
ELECTROMAGNETIC ENVIRONMENT
Do not use near (24 inches or closer) equipment sen-
sitive to electromagnetic interference.
This tanning device complies with International
Standards (as set forth in manufacturer’s declaration
following) for electromagnetic compatibility for medi-
cal electrical equipment and/or systems.
These standards are designed to provide reasonable
protection against harmful interference in a typical
medical installation.
However, because of the proliferation of radio-fre-
quency transmitting equipment and other sources
of electrical noise in healthcare and other environ-
ments, it is possible that high levels of such interfer-
ence due to close proximity or strength of a source
might disrupt the performance of this tanning device.
Medical electrical equipment needs special precau-
tions regarding EMC, and all equipment must be
installed and put into service according to the EMC
information specified in this manual
(chapter 4.1).
DIFFERENCE IN TEMPERATURE
Risk of damage by switching on the
power supply voltage.
When there are great differences in tempera-
ture between the transportation route and the
installation site the tanning device shall not be
put into operation immediately after being set
up.
• Before connecting the tanning device
to the power supply, wait at least for 2
hours.
2.10 Commissioning
DANGER
Damaged mains power cable
Risk of death or fatal injury due to electric
shock when touching a damaged mains
power cable.
• Only the manufacturer or specialized
companies may replace the mains
power cable!
Initial commissioning will be carried out by the man-
ufacturer’s own service technicians or by qualified,
trained and authorized service technicians. The tan-
ning device will be handed over ready for use.
As studio operator it is your responsibility to observe
the electrical regulations applicable at the installation
site.
The tanning device incorporates special preventive
measures with regard to the electromagnetic com-
patibility and must be installed and commissioned
according to the EMC instructions obtained from this
operating instructions.
If the tanning device has not been used for a lon-
ger period of time, then it must first be inspected by
qualified, trained and authorized service technicians,
before being put back into operation again.
Ensure no electromagnetic compatibility issues with
the siting
(chapter 4.1).