KBL 4800 alpha, Руководство по эксплуатации

Страница: 52 / 60

O p e r a t i n g I n s t r u c t i o n s | KBL 4800 alpha
52
ERROR MESSAGES
After the error has been eliminated, all error messages must be acknowledged by pressing START on the interior
control panel.
No. Status message Description Remedy
26
Frequency detection: power
supply connection faulty
(connector X6/E6)!
Frequency detection failed. No mains
voltage.
Check mainboard connector X6/E6.
28 Excess Temperature Temp. 1-wire sensor >= 70
0
C for 3min Contact your Customer Service.
29 Excess Temperature Temp. 1-wire sensor 80
0
C for 10sec Contact your Customer Service.
INFORMATION MESSAGES
No. Info. message Description Remedy
203
Fill level aquaCool canister
low
The content of the aquaCool canister is
sufficient for another 2.5 hours of operation
with a spraying time of 6 seconds each.
Replace the empty aquaCool canister with a full one.
Do not replace aquaCool with any other liquid.
204
Connection aquaCool unit
faulty
Communication between control and
module/interior control panel has been
interrupted. Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
205
Connection audio module
faulty
206
Connection inside display
faulty
207 aquaCool canister empty aquaCool canister empty.
Replace the aquaCool canister with a full one.
See chapter: Refilling Aroma and aquacool
208
Aroma supply low, please
renew
System has run out of scent.
Replace the Aroma tin.
See chapter: Refilling Aroma and aquacool
209
aircon: condensed-water
canister full, please empty Condensate canister of air-conditioning
unit full. Empty the condensate canister of the air-conditioning
unit, acknowledge the message by pressing START.
210
Low battery charge, please
renew Button cell (CR-2032) of the control board
discharged.
Replace the button cell (CR-2032).
211
Connection preselect display
faulty
Communication between control and
“preSelection” control panel has been
interrupted. Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
212
Connection RGB-module
faulty
213 SD card missing No SD card in the audio module.
Insert an original SD card.
See chapter: Recording to an SD card/Removing the
SD card
214 SD card unreadable SD card defective, incompatible content.
Insert a new original SD card. Acknowledge the
message by pressing START. See chapter: Recording
to an SD card/Removing the SD card. If the fault
persists, contact your Customer Service.
216 Voltage varies, blease check Power supply to the mainboard varies Check power supply to the mainboard.
217
No voice files on the SD
card, pleas check.
No voice files on the SD card found.
Rebuild voice folder on the SD card. If necessary
replace original SD card.
218 Connection DALI-unit faulty. DALI-unit - CAN-BUS connection lost. Contact your customer service.
219
Connection rubinColl unit
faulty. Driver beautyBooster. CAN-BUS con-
nection lost.
Contact your customer service.
230
Connection bluetooth
module faulty Communication between control and
bluetooth module has been interrupted.
Check / replace the patch cable. Acknowledge the
message by pressing START. If the fault persists,
contact your Customer Service.
231 No display
Internal notification - stored in the error log
(service technician information).
-