Kaysun KSWP-70 DR8, Инструкция по установке и эксплуатации

Страница: 7 / 32

04
• Do not install the unit in the following places:
- Where there is mist of mineral oil, oil spray or vapors. Plastic parts may deteriorate, and cause them to come loose
or water to leak.
- Where corrosive gases (such as sulphurous acid gas) are produced. Where corrosion of copper pipes or soldered
parts may cause refrigerant to leak.
- Where there is machinery which emits electromagnetic waves. Electromagnetic waves can disturb the control system
and cause equipment malfunction.
- Where flammable gases may leak, where carbon fiber or ignitable dust is suspended in the air or where volatile
flammables such as paint thinner or gasoline are handled. These types of gases might cause a fire.
- Where the air contains high levels of salt such as near the ocean.
- Where voltage fluctuates a lot, such as in factories.
- In vehicles or vessels.
- Where acidic or alkaline vapors are present.
• This appliance can be used by children 8 years old and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they are supervised or given instruction on using the unit in a safe
manner and understand the hazards involved. Children should not play with the unit. Cleaning and user maintenance
should not be done by children without supervision. ( only European)
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufaturer or its service agent or a similarly qualified
person in order to avoid a hazard.
• DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste seperatelly for special
treatment is necessary. Do not dispose of electrical appliances as municipal waste, use seperate collection facilities.
Contact your local goverment for information regarding the collection systems available. If electrical appliances are
disposed of in landfills or dumps, hazardous substance can leak into the groudwater and get into the food chain,
damaging your health and well-being.
• The wiring must be performed by professional technicians in accordance with national wiring regulation and this circuit
diagram. An all-pole disconnection device which has at least 3mm seperation distance in all pole and a residualcurrent
device(RCD) with the rating not exceeding 30mA shall be incorporated in the fixed wiring according to the national
rule.
• The appliance shall be installed in accordance with national wiring regulations.
• Confirm the safety of the installation area ( walls, floors, etc. ) without hidden dangers such as water, electricity, and
gas.Before wiring/pipes.
• Before installation , check whether the user's power supply meets the electrical installation requirements of unit (
including reliable grounding , leakage , and wire diameter electrical load, etc. ). If the electrical installation requirements
of the product are not met, the installation of the product is prohibited until the product is rectified.
• When installing multiple air conditioners in a centralized manner, please confirm the load balance of the three-phase
power supply, and multiple units are prevented from being assembled into the same phase of the three-phase power
supply.
• Product installation should be fixed firmly. Take reinforcement measures, when necessary.
NOTE
• About Fluorinated Gasses
- This heat pump unit contains fluorinated gasses. For specific information on the type of gas and the amount, please
refer to the relevant label on the unit itself. Compliance with national gas regulations shall be observed.
- Installation, service, maintenance and repair of this unit must be performed by a certified technician.
- Product uninstallation and recycling must be performed by a certified technician.
- If the system has a leak-detection system installed, it must be checked for leaks at least every 12 months. When the
unit is checked for leaks, proper record-keeping of all checks is strongly recommended.
• Equipment complying with IEC 61000-3-12.