Kaysun KMF-100 DVN4, Инженерный справочник

Страница: 112 / 140

V6R VRF 50Hz
Part 3 - S
yst
em Design and Ins
talla
tion
Mini Amazon III Series
111



4.3.5 Bending piping
Bending copper piping reduces the number of brazed joints required and can improve quality and save material.
Notes for installers
Piping bending methods

Hand bending is suitable for thin copper piping (Ф6. 35mm - Ф12. 7mm).

M echanical bending (using a bending spring, manual bending machine or powered bending machine) is suitable
for a wide range of diameters (Ф6. 35mm - Ф54.0mm).
Caution

When using a spring bender, ensure that the bender is clean
before inserting it in the piping.

After bending a copper pipe, ensure that there are no wrinkles
or deformation on either side of the pipe.

Ensure that bend angles do not exceed 90°, otherwise wrinkles
may appear on the inner side of the pipe, and the pipe may
buckle or crack. Refer to Figure 3-4.3.

Do not use a pipe that has buckled during the bending process;
ensure that the cross section at the bend is greater than 2/3 of
the original area.
Figure 3-4.3: Pipe bending in excess of 90 °
4.4 Refrigerant Piping Supports
When the air conditioner is running, the refrigerant piping will deform
(shrink, expand, droop). To avoid damage to piping, hangers or
supports should be spaced as per the criteria in the Table 3-4.2. In
general, the gas and liquid pipes should be suspended in parallel and
the interval between support points should be selected according to the
diameter of the gas pipe.
Suitable insulation should be provided between the piping and the supports. If wooden dowels or blocks are to be used, use
wood that has undergone preservative treatment.
Changes in refrigerant flow direction and refrigerant temperature result in movement, expansion and shrinkage of the
refrigerant piping. Piping should therefore not be fixed too tightly, otherwise stress concentrations may occur in the piping,
with the potential for rupturing.
Table 3-4.2: Refrigerant piping support spacings
Pipe (mm)
Interval between support points (m)
Horizontal Piping Vertical Piping
< Ф20 1 1.5
Ф20 – Ф40 1.5 2
> Ф40 2 2.5