Kaysun KCIS-52 DR11, Руководство по установке

Страница: 24 / 40

24
Table 8.2: Other Regions
b.
Using wire strippers, strip the rubber jacket
from both ends of signal cable to reveal about
15cm (5.9”) of the wires inside.
c.
Strip the insulation from the ends of the wires.
d.
Using a wire crimper, crimp u-lugs on the
ends of the wires.
2.
Remove the electric cover of the outdoor unit. If
there is no cover on the outdoor unit,
disassemble the bolts from the maintenance
board and remove the protection board.
(
See Fig. 8.1, 8.2)
Cover
Screw
Fig. 8.1
Indoor Unit Wiring
1. Prepare the cable for connection
a. Using wire strippers, strip the rubber jacket
from both ends of signal cable to reveal
about 15cm (5.9”) of the wires inside.
b. Strip the insulation from the ends of the wires.
c. Using wire crimper, crimp the u-lugs to the
ends of the wires.
2. Open the front panel of the indoor unit. Using
a screwdriver, remove the cover of the electric
control box on your indoor unit.
3. Thread the power cable and the signal cable
through the wire outlet.
Control box
Wire outlet
Fig. 8.3
4.
Connect the u-lugs to the terminals.
Match the wire colors/labels with the labels on the
terminal block, and firmly screw the u-lug of each
wire to its corresponding terminal.
Refer to the Serial Number and Wiring Diagram
located on the cover of the electric control box.
Control box
Protection Board
Fig. 8.2
3.
Connect the u-lugs to the terminals
Match the wire colors/labels with the labels on the
terminal block, and firmly screw the u-lug of each
wire to its corresponding terminal.
4.
Clamp down the cable with designated cable
clamp.
5.
Insulate unused wires with electrical tape. Keep
them away from any electrical or metal parts.
6.
Reinstall the cover of the electric control box.
Fig. 8.4
Magnetic ring
(if supplied and packed with the accessories)
Pass the belt through
the hole of the Magnetic
ring to fix it on the cable
Fig. 8.5

NOTE:
While connecting the wires, please strictly
follow the wiring diagram (found inside the
electrical box cover).
W
iri
ng
Rated Current of
Appliance (A)
Nominal Cross-Sectional
Area (mm²)

6 0.75
6 - 10 1
10 - 16 1.5
16 - 25 2.5
25- 32 4
32 - 45 6