KAULIN MFG. CO. Siruba LF-D6, Инструкция / Перечень запасных частей

Страница: 30 / 42

-26-
請確認步進驅動器
（
FD691
）設定值是否正確
Please confirm if the setting
value of the stepping driver
(FD691) is accurate?
Yes
請調整設定值
Please adjust the setting value.
No
更換步進驅動器
（
FD691
）
Change
the stepping driver
(FD691).
Yes
步進馬達仍然
無動作
The stepping motor
driver is still no signal.
請更換控制面板
（
FD683
）
Substitute the control
panel (FD683).
Yes
Yes
3.
步進驅動器設定
The setting value of the stepping motor driver
：
此處設定請勿調整
The setting here must not be adjusted.
步進馬達停止轉動時的保持電流值：
建議設定為中間值；過大步進馬達過熱；過小步進馬達扭力值不足
The holding electronic current value when the steppingmotor driver stops rotating:
Suggest the setting be the intermediate value
；
Bigger the value is, hotter the motor driver
is
；
smaller the value is, more insufficient the torsion of the stepping motor driver is.
步進馬達轉動時的電流輸出值：建議設定為 A ～ F ；
如遇到厚料時，建議將輸出值調大；
如果步進馬達過熱時，建議將輸出值調小
The electronic current output value when the stepping motor driver rotates:
Suggest set the value to be A ~ F.
For seaming on the heavy fabric, set the output value bigger;
if the stepping motor driver is overheated, adjust the value smaller.
A
9 8
0
F
E
D
C
B
12
3
4
5
6 7
RUN
ST
OP
Min Max
1 2 3 4
1P
TEST
OFF
H
2P OFF
ACD
F
4.
畫面顯示
E01 The panel displays E01
：
表示安全開關被觸動，無法回復。
It indicates that the safety lock switch is touched and cannot be reverted.
畫面顯示
E01
The panel
displays E01
檢查送具是否
閉合在支架上
Check if the feed dog on
the bracket is closed.
檢查安全開關連接線
(FD671)
是否鬆脫
Check if the safety lock
switch connection wire
(FD671) is loose.
請將送具閉合在送具上
再重新測試
Please let the feed dog be
closed and test again.
請重新連接後再測試
Please reconnect
and test again.
檢查電控箱內
連接線是否鬆脫
Check if the connection
wires in the electronic
control box are loose.
請重新連接後再測試
Please reconnect
and test again.
更換新的安全開關
(FD671)
Substitute another new
safety lock switch (FD671).
更換後再重新測試
Substitute another one and test.
更換新的控制板
(FD683)
Substitute another new
control board (FD683)
更換後再重新測試
Substitute another one and test.
更換後再重新測試
Substitute another one and test.
Yes No
No Yes
Yes
No
無法排除
E01
cannot solve E01
無法排除
E01
cannot solve E01