5
•
Lower float brackets (6)
• 3/8” washers (3)
Part 1
Part 2
1. Turn the unit upside down. Loosen and remove the
3/8” nuts on the three 9” bolts that are closest to the
motor unit. Place 2 Lower Float Brackets(Part #1) and
one 3/8” washer(Part #2) on each of the 9” bolts over
the bottom screen clips and replace the 3/8” nut.
2. Arrange the brackets into the position shown and
tighten down the nuts. Once the brackets are secure,
turn the unit back into its upright position.
3. Follow the instruction on the previous page
(LED3125 Assembly instructions) to mount the light
kit to the brackets.
waterproof connectors.
Make sure the orange or black oring is installed
on the plug side of the waterproof connector.
If
any are missing, check the packaging to see if any fell
off during shipping, or an extra oring was included if
there is one missing.
Hand tighten the waterproof connectors as shown in
Figure 11. Using a cable tie, tie the light kit power
cord to the float opposite the fountain power cord.
This will keep the cord from being damaged by the
fountain and balance the unit properly.
Next, cable tie each fixture cord to the float to protect
each fixture cord as shown in Figure 12.
Fig 11 Check for orange or black oring
Fig 12
7. Upon installation of the assembled unit, connect
your LED light kit to your field installed GFCI
protected outlet and timer.
Instructions For Mounting LED6125 and
LED6C11
Instructions for attaching brackets on the float prior
to mounting the light fixtures on 2 HP or larger Kasco
units.
Parts needed: