3
Fig 4
3. Install the 1/4” Flat Washer, 1/4” Lock Washer
and 1/4” Nut against the underside of the float tab as
shown in Figure 5. Tighten the nut until snug using
the 7/16” Wrench.
Fig 5
flat washer
lock washer
1/4” nut
4. Adjust the angle of the light as desired and tighten
the two brass thumb screws on the sides of the fixture
until snug. Do not over tighten. It is best to have all
three fixtures at the same angle.
5. Repeat steps 1 through 4 for the remaining fixtures.
Assembled light fixtures are pictured in Figure 6. Note
the orientation of the lights.
Fig 6
6. Connect each fixture cord to the power cord’s
waterproof connectors.
Make sure the orange or black oring is installed
on the plug side of the waterproof connector.
If
any are missing, check the packaging to see if any fell
off during shipping, or an extra oring was included if
there is one missing.
included in RGB3C5
•
B. Lower float brackets (6)
• C. 3/8” washers (3)
TOOLS & SUPPLIES NEEDED
• A. Two 7/16” Wrenches (or one wrench & a 7/16
socket with driver)
• B. Diagonal Pliers or Cutter for Nylon Zip Ties
•
C. Small flat blade screwdriver for wire terminals
Assembly Instructions
For ease of assembly, make sure the Aerating Fountain
is completely assembled. Place the assembly upright.
1. Install the mounting brackets to the light fixtures by
fitting the head of the #10 screw into the tabs on each
side of the fixture. Place one O-ring then lock washer
on each #10 screw then tighten the thumb screws on
each side hand tight only.
Fig 1
Instructions for mounting lights on model:
2400VFX, 3400VFX, 3400HVFX, 3400J, 3400HJ,
4400VFX, 4400HVFX, 4400J, 4400HJ
2. Insert the 1/4” x 1-3/8” bolt into the light fixture
bracket. Align the light fixture bracket to the float
tab by placing the bolt through the light mounting
hole (light fixture bracket is on top of the float tab) as
shown in Figure 4.