STEP FOUR:
First, thread the user supplied pipe extension (more
than 10 ft is not recommended) into the 4 Hole Angle
Bracket by hand to start to ensure the threads are
aligned properly. Then temporarily mount it to the
Dock Mount Base using one of the ½” Hex Head
Bolts included to tighten further. Hand tighten only.
STEP FIVE:
Remove the 4 Hole Angle Bracket from the Dock
Mount Base and attach the 4 Hole Angle Bracket to
the 9 Hole Plate using a ½ - 13x1 ¼” Hex Head Bolt,
½” Flat Washer and ½”-13 Nut. Hand tighten at this
point.
STEP SIX:
Adjust the angle of the 4 Hole Angle Bracket. The
deicer can be set in 15 degree intervals. Once the 4
Hole Angle Bracket is in the desired position, insert
one ½ - 13x1 ¼” Hex Head Bolts through the hole in
the 9 Hole Plate that is aligned with the hole in the 4
Hole Angle Plate. Use a ½” Flat Washer and ½”-13
Nut to hold the bolt in place and tighten using the
3/4” Wrench or Socket. Make sure all bolts and nuts
are now tight. (If more than one set of holes align use
the holes closest to the de-icer.)
STEP SEVEN:
Place the Clam Shell Pipe Clamp
onto the pipe extension. Make sure
the two halves are interlocked. To
interlock, insert the tabs into the
openings and rotate 90 degrees.
STEP EIGHT:
Line up the 3 holes of the Clam Shell Pipe Clamp
with the 3 vertical holes on the Dock Mount Base
(connected to the dock or piling). Insert a ½ - 13x1
¼” Hex Head Bolt into the top hole of the clamp and
base. Use the 1/2” Lock Washer and ½-13” Nut to
hold the bolts in place. Make sure the De-Icer is at
the correct desired depth and hand tighten. Repeat
with the two remaining holes and use the 3/4”
Wrench and 3/4” Socket and Ratchet to tighten all
three. (Use the 3 side holes shown in picture for
mounting on a dock, or use the top 3 holes shown in
picture when mounting to a piling.) Your Universal
Dock Mount is now ready for use.
The Industry Leader in
Ice Control Engineering.
KASCO MARINE, INC.
800 Deere Road
Prescott, WI 54021-1241
Phone (715) 262-4488 * Fax (715) 262-4487
www.De-Icer.com * [email protected]
