Karma Morgan Series, Руководство пользователя

Страница: 99 / 116

99
Load the battery back into the battery box. (Figure 6-8). Connect the red wire (marked with [A] ) with the
positive terminal (the red end). Connect the black wire (also marked with [A]) with the negative terminal
(the black end). Make sure the terminals are properly connected.
Adjust the strap first to so that the remaining end of the strap is not protruding out of the battery box.
(Figure 6-6)
Fixate the wires and the battery by pulling firmly on the battery strap. Fasten the strap firmly. (Figure 6-6)
Re-tighten the screws on the rear cover. (Figure 6-3 & 6-4)
Sling Seat
：
Remove the actuator and the front battery:
Use two 17mm open end wrenches to remove the screws for fixing the upper end of the actuator.
(Figure 6-17)
Remove the screws for fixing the lower end of the actuator. (Figure 6-18)
Remove the actuator and put it aside. (Figure 6-19)
Use 5mm L-shape wrench to remove the four screws which are used to fasten the fixing plate for the
actuator. (Figure 16-21)
Repeat steps 6.7.1 and 6.7.2 for replace batteries.
Install the fixing plate and the actuator back the powered wheelchair.(Figure 6-21, Figure 6-22)
Make sure the actuator and the powered wheelchair can work properly
Figure 6-17 Figure-18 Figure 6-19
Figure-20 Figure-21 Figure 6-22