Karma Morgan Series, Руководство пользователя

Страница: 55 / 116

55
15.4. Seat angle adjustment
Morgan Sling Seat with Tilting Function
：
The initial seat angle is set at 2°. If the desired seat angle can be 5°, pull out the hair pin cotter and E Ring
from the lower hole (Figure 5.3.9-1) and insert them in the upper hole.
Figure 5.3.9-1 Figure 5.3.9-2
Morgan Sling Seat without Tilting Option
The initial seat angle is set at 2°. If the desired seat angle can be 5°, Loosen the screws at both the left side
and right side from the lower hole (Figure 5.3.9-2) and insert them in the upper hole.
Morgan KISS Seat with Tilting Option (Including seat height adjustment)
KISS Seat with Tilting option is shown as Figure 5.3.9-3.
Depending on the user's needs, check table 5-1 to see whether it is necessary to adjust the plates
Ⅰ
,
Ⅱ
,
Ⅲ
,
Ⅳ
and
Ⅴ
. (Figure 5.3.9-4, Figure 5.3.9-8) If it necessary to adjust the adjustable seat height plate, carry out
the following steps. Use the #5 Allen Key Wrench to remove the screws from F3, C and P4 on both sides of
the seat base. Remove Plate
Ⅳ
. (Figure 5.3.9-4) Loosen the screw from P3. Remove the screw from R1 to
R2 if it is necessary. Re-tighten screws P3 and R1 or R2 according to table 5-1. (Figure 5.3.9-5) Put Plate
Ⅳ
and the screw back P4, but do not tighten it yet. Use the #5 Allen Key Wrench to loosen the screws from P,
C and P2 on both sides of the seat base. Remove the screw from C to A, B or D if it is necessary. Re-tighten
screws. (Figure 5.3.9-6) According to table 5-1, Replace screws on plate plates
Ⅳ
(A, B, C or D) and
plate
Ⅴ
(F1, F2, F3, F4, F5 or F6). Re-tighten all screws. (Figure 5.3.9-4) Ensure all screw are properly
tightened.
Figure 5.3.9-3