Karma Morgan Series, Руководство пользователя, Страница: 98 / 116

98
Figure6-7 Figure6-8 Figure6-9 Figure6-10
Figure 6-11 Figure 6-12 Figure 6-13 Figure 6-14
Figure 6-15 Figure 6-16
Remove the Rear Battery
Remove the two screws on the battery casing in the back of the wheelchair. (Figure 6-11)
Remove the rear battery casing (Figure 6-12)
Place the back casing aside and pull the cables out. (Figure 6-13)
Loosen the battery strap. (Figure 6-14)
Disconnect both wire terminals of the battery. Cap the wire terminals to avoid any short circuit.
(Figure 6-15)
Hold the rear battery and slightly pull it out.
Place the rear battery on the ground. Put aside the wires detached from the front battery and keep
them away from touching the terminals of the batteries. (Figure 6-16)
Load the Batteries
Load the batteries by reversing the procedures of Section 6.7.1 Remove the Batteries.
Load the Rear Battery:
Load the rear battery back into the battery box.(Figure 6-15). Connect
the red wire
(marked with [A])
with the positive terminal (the RED end). Connect the black wire (also marked with [A]) with the
negative terminal (the BLACK end). Make sure the terminals are properly connected.
Adjust the strap first to so that the remaining end of the strap is not protruding out of the battery box.
(Figure 6-14)
Fixate the wires and the battery by pulling firmly on the battery strap. Fasten the strap firmly.
(Figure 6-14)
Re-tighten the screws on the rear cover. (Figure 6-11 & 6-12)
Load the front battery: