Kärcher MC 130, Руководство пользователя

Страница: 86 / 414

-
34
The bypass valves are located on the bottom in the front
area of the tail.
1 Bypass valve

Unscrew the bypass valves by 3 revolutions
(SW 24 mm).

Fasten the towing rope or towing bar to the towing eye.

Slowly drag the vehicle onto the transport vehicle.

After towing, close the spring load of the parking brake
again and close the bypass valves.
몇
WARNING
Risk of personal injury or damage!

Consider the weight of the vehicle when storing it.
If the vehicle is not used for a longer period of time, ob-
serve the following points:

Park the vehicle at a safe, level and dry place.

Stop the machine.

Set the travel direction lever to the NEUTRAL position
- central position
Note
In this position the parking brake is automatically ap-
plied, the vehicle does not drive.

Raise left and right side brush.

Switch off the water pump.

Switch off the suction turbine.

Turn ignition key to "STOP" and remove it.

Change the engine oil and the oil filter.

If frost is expected, check whether there is enough anti-
frosting agent in the cooling water.

Empty the water reservoir and the pipe system; refer to
chapter "Maintenance Work/Empty water reservoir")
(option).

For the water circulation system (option) drain the wa-
ter from the waste container.

Clean the inside and outside of the sweeper.

Turn the main switch to position 0.

If it is stored for more than 1 month, jack up the vehicle.

Charge battery approx. every 2 months.

First switch off the appliance and remove the ignition
key before performing any cleaning or maintenance
tasks on the appliance, replacing parts or switching
over to another function.

The battery must be disconnected prior to working on
the electrical system.

Maintenance work may only be carried out by approved
customer service outlets or experts in this field who are
familiar with the respective safety regulations.
몇
WARNING
Risk of burns!

Allow the vehicle to cool down sufficiently before re-
moving the panels.
For the performance of various maintenance tasks the mo-
tor cowlings must be removed.

Remove the waste container if necessary, see Chapter
"Removing the waste container from the device".
1 Closure of lateral motor cowling
2 Lateral motor cowling
3 Cover switching valve
In order to remove the lateral motor cowling, the complete
waste container must be slightly raised first.

Remove the cover switching valve and set the switch
lever to the "Attachment frame tilting" position, then
slightly raise the attachment frame (approx. 15 cm),
see Chapter "Switchover waste container/lifting plat-
form",

Open both locks of the lateral motor cowling.

Lift the lateral motor cowling up towards the top and re-
move it to the side.

Insert the covers from the side.

Hook the cover into the mounting groove on the upper
edge.

Slide the cover into the desired position and secure
with the locks.
9.2.3 Open bypass valves
10 Storage
11 Care and maintenance
11.1 General notes
11.2 Cowlings
11.2.1 Removing/attaching the lateral motor
cowlings
11.2.1.1 Remove the lateral motor cowling
11.2.1.2 Attaching the lateral motor cowling
86 EN