Kärcher MC 130, Руководство пользователя

Страница: 80 / 414

-
28
몇
CAUTION
Risk of accident!

Check the lock for correct adjustment each time you in-
stall attachments.
1 Lock lever
2 Tension nut
The following points must be observed when securing the
attachments:

The attachments (e.g. sweeping system, front power
lift) are secured by pressing the locking lever down, the
lock must engage past the dead centre.

If the lock is not set properly, it must be adjusted on the
tension nuts.
몇
CAUTION
Risk of burns on account of hot hydraulic quick couplers!
Wear gloves while separating the couplings.
To remove the waste container from the vehicle, 2 rear and
2 lateral supports are required (optional accessory, order
no. 2.321-028.0).

Place the vehicle on a level and solid surface to re-
move/attach the waste container.

Empty waste container and water tank prior to removal.

Remove the suction hose.

Disconnect the water connections between the suction
mouth and the vehicle.

Separate the electric connectors.

Remove the hydraulic hoses; in order to do so, depres-
surise the hydraulic system, see Chapter "Depressuris-
ing the hydraulic system".
2 supports at the rear and 2 supports at the side are need-
ed for removing the waste container.
Note
When Toyo 225 tyres are fitted, the removal and installa-
tion of the waste container can be more difficult due to col-
lision with the vehicle chassis. This problem can be solved
by using special adapter plates screwed to the rear sup-
ports (order no. available on request). Newer supports are
already fitted with the adapter plates.
1 Suction hose
2 Hose recycled water
3 Water system
4 Locking tap

Close the stop cock of the water circulation system.

Disconnect coupling of the water circulation system,
suspend the hose into the holder.

Disconnect coupling recycled water, suspend the hose
into the holder.
1 Switch position Lower attachment frame
2 Switch position Raise attachment frame
3 Switch lever in "Attachment frame tilting" position

Set the switch lever to the "Attachment frame tilting" po-
sition (see Chapter Switchover waste container/attach-
ment frame tilting").
8.1 Checking/adjusting attachment lock
8.2 Waste container
8.2.1 Preparation
8.2.2 Removing the waste container
80 EN