Kärcher KM 100/100 R LPG, Руководство пользователя

Страница: 28 / 269

-
10

Rear sealing strip

Set the distance between the sealing
strip and the floor so that the bottom
edge trails behind at a distance of be-
tween 5 and 10 mm.

If worn, replace.

Remove roller brush.

Unscrew retaining nuts for rear sealing
strip.

Screw on new sealing strip.

Side sealing strips

Slightly loosen retaining nuts for the
side sealing strip (to replace, unscrew).

Screw on new sealing strip without fully
tightening the nuts.

To set the floor clearance, insert a
sheet with a thickness of between 1 and
2 mm under the sealing strip.

Adjust sealing strip.

Tighten nuts.

Screw on side panels.

Push in the waste containers on both
the sides and lock them.
몇
Warning
Empty waste container before replacing
dust filter. Wear a dust mask when working
around the dust filter. Observe safety regu-
lations on the handling of fine particulate
material.

Turn main key to "0" and remove it.

Open the hood, insert retaining rod.

Pull out the filter holder to the maximum
possible extent and lock.

Remove the lamella filter.

Insert new filter.

Make sure driver engages with holes on
drive side.

Lock the handle of the filter cleaner
back into place.
Note: Make sure when installing the new
filter that the fins are not damaged.

Lift filter case seal out of groove in the
cover.

Insert new seal.

Check tension of drive belt and V-belt of
the suction blower, also check for wear
or damage.

Check tension, wear and damages on
the V-belt of the sweep roller drive.

Chek the cup seal at the suction blower
regularly to see that it sits properly.

Loosen screws on both sides of the
panel.

Replace defective fuses.

Replace front panel.
Note: Only use fuses with identical safety
ratings.
Note
The engine is equipped with an oil deficien-
cy switch. When the fill level is insufficient,
the engine switches off and can only be re-
started once the engine oil has been re-
plenished.

Danger
Risk of burns on account of hot surfaces!

Allow engine to cool down.
Replacing dust filter
Replacing filter case seal
Checking drive belt
Check cup seal
Replacing fuses
Check engine oil level and top up, if re-
quired
27 EN