Kärcher KM 100/100 R LPG, Руководство пользователя

Страница: 27 / 269

-
9

Set programme switch to step 1 (driv-
ing). Roller brush is raised.

Turn main key to "0" and remove it.

Secure the machine with wheel
chock(s) to prevent it from rolling away.

Raise slightly the waste containers on
both sides and pull them out.

Loosen the front attachment screw of
the right-hand side panel.

Loosen the rear attachment screw on
the right-hand side panel.

Remove side panel.

Loosen the screws.

Loosen the attachment screw of the
bowden cable and remove the bowden
cable.

Unscrew the screw on the pivoting point
of the roller brush arm.

Pull out roller brush swinging arm.

Remove the roller brush cover.

Pull out roller brush.
Installation position of roller brush in direc-
tion of travel

Push new roller brush into the roller
brush housing and onto the drive pin.
Note: When installing the new roller brush,
ensure correct positioning of the bristle as-
sembly.
Note: Adjust the bowden cable, so that the
roller brush is lifted approx. 10 mm off the
floor.

Position roller brush cover.

Install the roller brush arm.

Hook the Bowden cable in.

Tighten the fastening screws.

Screw on side panel.

Push in the waste containers on both
the sides and lock them.

Set programme switch to step 1 (driv-
ing). The side brush and roller brush are
raised.

Drive sweeper on to a smooth, even
surface covered with a visible layer of
dust or chalk.

Set programme switch to step 2. Roller
brush is lowered. Slightly press down
on the drive pedal and allow the sweep
brush to briefly rotate.

Raise roller brush.

Press pedal which raises bulk waste
flap and keep pressed.

Drive machine backwards.
The sweeping track should have an even
rectangular shape which is between 50 and
70 mm wide.
Note:
The side brush floating mounting of
the roller brush adjusts the sweeping track
as the bristles wear down. The roller brush
must be replaced if it becomes too worn.

Park the sweeper on an even surface.

Set programme switch to step 1 (driv-
ing). Roller brush is raised.

Turn main key to "0" and remove it.

Secure the machine with wheel
chock(s) to prevent it from rolling away.

Raise slightly the waste containers on
both sides and pull them out.

Open the fastening screws of the side
panels on both sides.

Remove side panels.

Front sealing strip

Slightly loosen retaining nuts for the
front sealing strip; to replace, unscrew.

Screw on new sealing strip without fully
tightening the nuts.

Adjust sealing strip.

Set the distance of the sealing strip to
the floor so that the bottom edge trails
behind at a distance of between 35 and
40 mm.

Tighten nuts.
Check the sweeping mirror of the
sweeping roller
Adjusting and replacing sealing strips
26 EN