KanexPro EXT-PROCTRL, Руководство пользователя

Страница: 39 / 57

39
necessary. Selecting “Full Screen” will stretch the source to fit the video wall,
regardless of the original source’s aspect ratio.
• Wall Size: Select the size of the video wall, measured in number of monitors tall by number
of monitors wide. The maximum number of displays in a single video wall is 64 (8x8).
• Bezel Top/Bottom/Left/Right:
Set the size, in pixels, of the bezel surrounding the
monitors used in the video wall.
Note: It is strongly recommended to use the same make and model for all displays within a video
wall to avoid bezel and panel size discrepancies.
• Receiver Selection:
This is a list of all available receivers in the system. Drag and
drop each receiver to it’s correct position within the video wall grid to the right of
the list. After placement, each receiver’s name will be displayed within the selected
location of the video wall and it will turn red or green. Green panels within the video
wall indicate that a display has been assigned and is in video wall mode, red panels
indicate that a display has been assigned, but is not active/ in the correct mode, and
blue panels indicate that no display has been assigned yet.
• Save Group:
Click this button to save changes to the current video wall configuration
without executing or activating it.
• Execute: Click this button to save changes to the current video wall configuration
and then execute the changes. If the video wall was not already active, this will also
activate it.
6.6.8 Multiview Tab
This tab provides a way to configure or modify the multiviewer functionality of each
receiver. All aspects of a multiviewer output can be configured here including window
number and arrangement, output resolution, and window sources.
Note: Using a source within a multiviewer output will increase the bandwidth requirements of
the associated transmitter. The increase in bandwidth usage depends on the pixel size of the
window required by the multiview output and the frame rate of the source. In order to minimize
the bandwidth impact with 4K sources, it is strongly recommended to enable the “Multiview Divide
FPS by two” feature of the transmitter.