KanexPro EXT-PROCTRL, Руководство пользователя

Страница: 14 / 57

14
• Source to Multiple Receiver Routing: To route an HDMI audio source to multiple
receivers at the same time, click and drag the source’s button on the left to a
Group button or the “All” button on the right side, then release the mouse button.
If the routing was completed successfully, the source’s name will appear within all
appropriate buttons.
• Stop Stream: To stop the independent HDMI audio stream from a single source, drag
the source down to the “Stop” button at the bottom of the window, then release the
mouse button. To stop ALL independent HDMI audio streams drag the “All” button
down to the “Stop” button.
Note: When a receiver’s HDMI Audio is set to “Follow Video in Genlock Mode” and scaling on that
output has been disabled (Bypass), the audio output on that receiver cannot be stopped by using
this control.
• HDMI Audio Receiver:
This section provides drag-and-drop buttons for all receivers
detected by the system as well as a button target to stop one or all independent
HDMI audio streams.
Note: When a receiver’s HDMI Audio is set to “Follow Video in Genlock Mode” and scaling on
that output has been disabled (Bypass), the HDMI audio routing selection is ignored, and the
audio embedded with the HDMI source will always be output. In these instances a (!) mark will be
displayed.
• Stop Stream: To stop the HDMI audio stream on a single display, drag the display
down to the “Stop” button at the bottom of the window, then release the mouse
button. To stop HDMI audio on ALL video outputs, drag the “All” button down to the
“Stop” button.
Note: When a receiver’s HDMI Audio is set to “Follow Video in Genlock Mode” and scaling on that
output has been disabled (Bypass), the independent audio route will be stopped, however the
HDMI embedded audio will continue to be output normally.