K&M FSD3000, Перевод оригинального руководства по эксплуатации

Страница: 35 / 44

34 35
EN
Juice Dispenser FSD3000 / FSD3100 © K. & M. Holland GmbH © K. & M. Holland GmbH Juice Dispenser FSD3000 / FSD3100
EN
Subject to technical change without prior notice! Version 4.0, 12/2017 Subject to technical change without prior notice! Version 4.0, 12/2017
Liquid (water/juice)
escaping from the
drainpipe
Solenoid valve leaking
Contact the service company to
repair/adjust the valve
Foreign objects in valve
Cooling block ices or
freezes
Temperature sensor not
mounted properly
Position temperature sensor properly,
contact a repair technician
Thermostat set
incorrectly
Correct setpoint on the thermostat,
contact a repair technician
Temperature inside
the cold storage area
too low
Thermostat set
incorrectly
Temperature inside
the cold storage area
to high
Thermostat set
incorrectly
Insufficient ventilation of
the refrigerant condenser
Clean the condenser (insured to
disconnect the power!), contact a repair
technician, if necessary
Door seal is leaking Replace the door seal
Inside fan faulty
Replace the inside fan, contact a repair
technician
Cooling system faulty Contact a repair technician
Door has been kept open
for too long
Do not open the door unnecessarily
11. Energy-saving and environmental awareness
n
A contaminated refrigerant condenser causes an increased level of power consumption.
Clean the condenser as described on page 31 “Maintenance and Cleaning”.
n
High room temperatures, direct sunlight, or installing the equipment near a heat source
(stove, heater) increases the power consumption.
n
Do not open the door unnecessarily.
n
Inspect the condition of the door seal during regular maintenance schedules.
n
A cooling temperature set too low, increases the power consumption!