Kaisai KMK-60RY1, Руководство по обслуживанию

Страница: 83 / 114

M thermal Split
80 202004
Midea
M t
her
ma
l S
pli
t Ser
vice M
anual
port CN4 on the KHA-12(14,16)RY3 outdoor unit refrigerant system main PCB (labeled 15 in Figure 4-2.4 in Part 4, 2. 3 "Main PCB for
Refrigerant System, Inverter Module").
2. Final outlet water temperature sensor and water side heat exchanger water outlet temperature sensor connections are port CN6 on the hydronic box
main PCB (labeled 10 in Figure 4-2.1 in Part4, 2.2 "Main PCB for Hydronic System"). Domestic hot water tank temperature sensor connection is port
CN13 on hydronic box main PCB (labeled 13 in Figure 4-2.1 in Part4, 2.2 "Main PCB for Hydronic System").
3. Measure sensor resistance. If the resistance is too low, the sensor has short-circuited. If the resistance is not consistent with the sensor’s
resistance characteristics table, the sensor has failed. Refer to Part 2, 1 “Layout of Functional Components” and to Table 5-5.1 or 5-5.2 in Part 5, 5.1
“Temperature Sensor Resistance Characteristics”.
4. High pressure switch connection is port CN13 on the KHA-06(08,10)RY1 outdoor unit refrigerant system main PCB (labeled 16 in Figure 4-2.2 in
Part4, 2.3 "Main PCB for Refrigerant System, Inverter Module"). port CN31 on the KHA-12(14,16)RY3 outdoor unit refrigerant system main PCB
(labeled 20 in Figure 4-2.4 in Part 4, 2. 3 "Main PCB for Refrigerant System, Inverter Module").
5. Measure the resistance among the three terminals of the pressure sensor. If the resistance is of the order of mega Ohms or infinite, the pressure
sensor has failed.
6. High pressure side blockage causes discharge temperature to be higher than normal, discharge pressure to be higher than normal and suction pressure
to be lower than normal.
7. Check air side heat exchanger, fan and air outlets for dirt/blockages.
8. Check the water side heat exchanger, water piping, circulator pumps and water flow switch for dirt/blockages.
Midea CAC Confidential
M thermal Split
202004 81
4.19 P5 Troubleshooting
Digital display output 4.19.1
Description 4.19.2

High temperature difference between water side heat exchanger water inlet and water outlet
temperatures protection.

Split stops running.

Error code is displayed on hydronic box main PCB and user interface.
Possible causes 4.19.3

Temperature sensor not connected properly or has malfunctioned.

Water piping contains air.

Insufficient water flow.

Hydronic box main PCB damaged.
Midea CAC Confidential
Split