B
C
D
A
E
Hook
Connecting point of
refrigerant pipe
Connecting point of
refrigerant pipe
Drain point
(gas side)
(Liquid side)
4
Keep indoor unit, outdoor unit, power supply wiring and
transmission wiring at least 1 meter away from televisions
and radios. This is to prevent image interference and noise
in those electrical appliances. (Noise may be generated
depending on the conditions under which the electric wave
is generated, even if 1 meter is kept.)
CAUTION
- There is enough room for installation and maintenance.
- The ceiling is horizontal, and its structure can endure the weight
of the indoor unit.
- The outlet and the inlet are not impeded, and the influence of
external air is the least.
- The air flow can reach throughout the room.
- The connecting pipe and drainpipe could be extracted out easily.
- There is no direct radiation from heaters.
1.1 Installation place
1.2
The dimension of the unit
The indoor unit should be installed in a location that meets the
following requirements:
1. INDOOR UNIT INSTALLATION
All the pictures in this manual are for explanation purpose only.
There may be slightly different from the air conditioner you
purchased ( depend on model ). The actual shape shall prevail.
NOTE
>35mm
>1000mm
>3
5m
m
>3
5m
m
MODEL(
)
Btu/h
AA
BB
CC
DD
EE
30K
36K/42K/48K/55K
18K/24K
1650
1068
1285
675
675
675
235
235
235
1565
983
1200
220
220
220
Unit:mm
Unit:mm
1.3 Install the main body
1 Installing 10 hanging screw bolts. (4 bolts)
O
O
Please refer to the following figures for positioning 4 screw bolts.
Evaluate the ceiling construction and please install with 10
hanging screw bolts.
The handling to the ceiling varies from the constructions,
consult the construction person for the specific condition.
- Do keep the ceiling flat. Consolidate the roof beam to avoid
possible vibration.
- Cut off the roof beam.
- Strengthen the place that has been cut off, and consolidatethe
roof beam.
After the selection of installation location, position the refrigerant
pipes, drain pipes,indoor & outdoor wires to the connection
places before hanging up the machine.
The installation of hanging screw bolts.
5
1.3.4 Steel roof beam structure
Install and use directly the supporting angle steel.
Hanging screw bolt
Supporting
angle steel
Hanging bolts
2 Overhanging the indoor unit
3. Ceiling Installation
4. Wall Mounting Installtion
- Locate the hanging arm on the hanging screw bolt.
Screw nut
Shockproof cushion
Hanging arm
Hanging
screw bolt
Washer
Confirm the minimum drain tilt is 1/100 or more
NOTE
1.3.1 Wooden construction
1.3.2 New concrete bricks
1.3.3 For Original concrete bricks
Put the square timber traversely over the roof beam, then install the hanging
screw bolts.
Inlaying or embedding the screw bolts.
Use embedding screw bold, crock and stick harness.
Timber over the beam
Roof beam
Ceiling
Hanging screw bolts
(Blade shape insertion)
(Slide insertion)
Steel bar
Embedding screw bolt
(Pipe hanging and embedding screw bolt)
Install the hanging hook with expansible bolt into the concrete
deep to 45~50mm to prevent loose.
- Remove the side board and the grille.
Hanging
screw bolt
Hanging arm
Grille
Side board
20
25
m
m
>2
0m
m
Downward declicity lower between(1-2)/100
Connecting point of
refrigerant pipe(gas side)
Connecting point of
refrigerant pipe(Liquid side)
Drain point
7
kaisai.com
