Kaco blueplanet 40.0 TL3, Инструкция по эксплуатации

Страница: 28 / 52

Configuration and Operation
Page 28 Installation Instructions KACO blueplanet 32.0 TL3 / 40.0 TL3 / 50.0 TL3
Operating state LEDs Display Description
Non-feed-in
operation
Status message The display shows the corresponding message.
Voltage Fault message The display shows the corresponding message.
The red “Fault” LED is illuminated.
8.1.2 Graphical display
The graphical display shows measured values and data and allows the confi guration of the inverter using a graphical
menu. In normal operation, the backlighting is switched off . As soon as you press one of the control buttons, the back-
lighting is activated. If no button is pressed for an adjustable period of time, it switches off again. You can also activate or
deactivate the backlighting permanently.
NOTICE
Depending on the tolerances of the measuring elements, the measured and displayed values are not
always the actual values. However, the measuring elements ensure maximum solar yield. Due to these
tolerances, the daily yields shown on the display may deviate from the values on the grid operator’s
feed-in meter by up to 15%.
After being switched on and after initial commissioning is complete, the inverter displays the start screen (the desktop). If
you are in the menu and do not touch the control buttons for two minutes, the inverter returns to the desktop.
For initial commissioning, see section 8.2 on page 30.
1
2
3
4
5
6
7
8
Figure 21: Desktop
Key
1 Current date 6 Status bar
2 Current power 7 Current time
3 Menu indicator 8 Feed-in indicator
4 Daily yield
5 Annual yield
8.1.3 Control buttons
The inverter is operated using the 4-way button and the OK and ESC buttons.