Kaba Mas DKX Series, Руководство по установке

Страница: 20 / 38

20
D. Install cap (i) to cover keyhole. The cap has a
small groove on one edge to allow ease of
removal. This should be facing down. Insert
bottom snap of cap in lever hole below the
cylinder. With a small screwdriver, push top snap
of cap down while pushing the cap into place.
E. To remove the cap (i) , insert a small flat
screwdriver into this groove and gently pry the
cap off, being careful not to damage it. Cover the
bottom of the lever to protect the finish from
being scratched through the process of removing
the cap.
Change Key-in-Lever Lock Cylinders
A. Loosen the set screw to free the lever. ( just
1
/
4
to
1
/
2
turn )
B. Remove the cap from the outside lever (h) .
C. Insert key (n) .
D. Turn the key clockwise until it stops.
E. Release key (n) .
F. Use a small flat screwdriver to push in the lever
catch through the small hole underneath the
outside lever.
G. Pull the outside lever (h) off of the lock housing.
( Be careful not to lose the cylinder plug (k) .
If it is difficult to pull the lever, slightly tighten or
loosen the set screw
.)
H. Replace the old cylinder with the new one in the
lever handle. (
Only the same kind of cylinder
with 2 grooves in cross in the end of the cylinder
plug can be used on the lock.)
I. Re-insert the cylinder plug (k) .
J. Hold the cylinder (j) and plug (k) in place, insert
the key.
Follow steps For K-I-L Key C to H and test as per Test the
Operation of the Outside Lever, and Test the Mechanical
Key Override with Change Key
instructions.
Figure 18
Figure 19
20