3 3
Installation and Start up cont.
INSTALLATION OF PNEUMATIC TANK SENSORS AND CONTROLS
If supplied by K SYSTEMS CORP. , see enclosed Manufacturer's manual or Data Sheet on
installation of tank transmitters.
INSTALLATION OF PNEUMATIC TANK SENSOR SIGNAL LINES
1.
To connect incoming Pneumatic Sensor Air Lines see the following Data Sheets:
.
Incoming signal lines must be connected in the positions as outlined on the Data Sheets.
Pneumatic Sensor tubing - KIO-12 PNEUMATIC INPUT ENCLOSURE LAYOUT
Data Sheet #DS-112590PNI12
- KIO-16 PNEUMATIC INPUT ENCLOSURE LAYOUT
Data Sheet #DS-010991PNI16
2 .
Signal air lines from the tank sensor controls are to be installed to the solenoid
associated to P/I transducers as labeled or in the order as shown on the Data Sheet and
Multi-tank Inventory screen. The transducers are positioned in the rack from left to
right 1-12. The first tank displayed in CHannel #1 on the Multi-tank screen (upper
left) is associated with P/I rack Position #1 (far left).
3 .
Do not pressurize enclosure. Only transmitter air lines should be brought into the
enclosure and they must be connected to P/I converter or capped. No other air device
should be installed in enclosure.
4 .
Pneumatic air leaks will produce incorrect inventory values. Check for leaks with air
line not connected to P/E rack as
overpressure can damage the P/I transducers
.