JYTEK PCIe-69834, Руководство пользователя

Страница: 38 / 50

28 Operations
Table 3-6: Card Number Configuration Settings
Default card number is 15.
3.7.2 SSI_TRIG
As an output, the SSI_TRIG signal reflects the trigger event signal
in an acquisition sequence. As an input, the PCIe-
69834
accepts the SSI_TRIG signal to be the trigger event source. The
signal is configured in the rising edge-detection mode.
3.8 Multi-boot
The PCIe-
69834
supports software-based firmware updates. If
firm-ware updates fail, the system may be unable to recognize
the
module, in which case the following steps may solve the
problem.
1. Config SW2 to "on"
2. Install the module and restart the system
3. If the module is recognized, update firmware again
(ensure the firmware you updated is workable)
4. Turn off the system, config SW2 to "off" and restart the
system.
The default state of SW2 is "off".
If the problem remains, please contact FAE.
ON OFF OFF ON 9
ON OFF ON OFF 10
ON OFF ON ON 11
ON ON OFF OFF 12
ON ON OFF ON 13
ON ON ON OFF 14
ON ON ON ON 15
Slider 1 Slider 2 Slider 3 Slider 4 Card #