JW Fishers SeaOtter-2, Руководство по эксплуатации

Страница: 20 / 29

20
Powering up the SeaOtter-2
The first power up and checkout will be done out of water (do not turn on front lights or
run motors for more than a second or two.)
SeaOtter-2
250 ft
Umbilical
cable
Umbilical
cable
extension
First test run (out of water):
1) Turn off the Master Motor Switch on the control panel.
2) Rock each propeller back and fourth (1/4 turn) a few times to insure motors are free to turn (if
the ROV has been in storage the seals can stick, this rocking frees the seals.)
3) Turn on the Power On Switch on the control panel.
4) The monitor will be blank and the control panel readout will display: JW Fishers
SeaOtter-2
5) After 5-10sec delay (internal self check), the monitor will display the video from the selected
camera. The System in ready to go.
Note: if the video does not display, check the Monitor Source switch on the control box cover. It
should have ROV selected as the source.
Horizontal Motors
Joystick
Vertical Motors
Joystick
Camera Pan Left/Right
Camera Tilt Up
Camera Tilt Down
Lights On
Lights Off
120vac
(only)
Buoyancy collars
(over in-line connectors)