JW Fishers SeaOtter-2, Руководство по эксплуатации

Страница: 18 / 29

18
Cabling the SeaOtter-2
The drawing below shows the cable connections for the SeaOtter-2.
Step 1.
After opening the control box cover, plug the cable from the cover into the Video Display connector
on the control panel. Be careful the cover does not fall forward (closed) after the cables have been
plugged into the control panel. The cover can be removed by removing (pull out) the two pins in the
hinge.
Step 2.
Attach the umbilical cable to the ROV and to the control box. Be careful while handling the con-
nectors. The pins or internal wiring can be broken if twisted or bent sharply. An umbilical extension
cable can be ordered if needed, the total length cannot exceed 500. A buoyancy collar goes over
the connectors.
Step 3.
If the video is going to be recorded, then connect the recorder (not supplied by JWF) to the Video
Out connector on the control panel. Also include a cable between the recorder and Audio Out
connector on the control panel if a microphone (not supplied by JWF) is being used. The micro-
phone has it’s own connector on the control panel.
Step 4.
If a remote monitor is being used, connect the monitors cable to the Video Out connector on the
control panel. Monitor power can be plugged into control panel outlet (120 vac).
If both a recorder and a remote monitor is being used, then connect the recorder cable to the
Video Out connector (use both the video and audio cables) and connect the monitor to the DVD
output connectors. Monitor and recorder power can be plugged into control panel outlet (120 vac).
SeaOtter-2
Microphone
120vac
(only)
220vac
to
120vac
transformer
Ground Fault
Power Source
if 120vac
if 220vac
250 ft
Umbilical
cable
Umbilical
cable
extension
12vdc
to
120vac
inverter
if 12vdc
Buoyancy collars
(over in-line connectors)
Remote
Monitor
DVD Recorder