JVC SP-AD300, Инструкция по эксплуатации

Страница: 9 / 20

9
Installing the Batteries into the Remote Control
Removing the insulating strip
Remove the insulating plastic strip from the battery if the
battery is being used for the first time. It is located at the
bottom back side of the remote control.
Battery Replacement for the Remote Control
The remote control requires a CR2025, 3V Lithium battery.
1. Slide and hold the battery release tab in the direction
of the arrow and at the same time pull out the battery
holder.
Handling the Battery
• Improper or incorrect use of batteries may cause corrosion or battery leakage, which could cause fire,
personal injury or damage to property.
• Install the battery correctly by following the polarity (+ and –) indications in the battery compartment.
• When the battery is exhausted, the remote control will not function.
• Only use the battery type indicated in this manual.
• Do not dispose of the used battery as domestic waste. Dispose of it in accordance with the local
regulations.
• Small button cell batteries such as the one used in the remote control are easily swallowed by young
children and this is dangerous. Keep loose button cells away from young children and make sure that
the battery holder tray is secure in the remote control. Seek medical advice if you believe a cell has
been swallowed.
Handling the Remote Control
• Do not drop the remote control.
• Do not allow anything to impact the remote control.
• Do not spill water or any liquid on the remote control.
• Do not place the remote control on a wet object.
• Do not place the remote control under direct sunlight or near sources of excessive heat.
• Remove the battery from the remote control when not in use for a long period of time, as corrosion or
battery leakage may occur and result in physical injury, and / or property damage, and / or fire.
• When the battery is exhausted, the remote control will not function.
2. Fully pull out the battery holder and remove the old
battery.
3. Replace with a new battery.
4. Insert the battery holder back into the remote control.
SP-AD300_IB.indd 9 17/04/2015 10:41