JVC CL-S500 Series, Руководство по установке

Страница: 20 / 40

- 20 -
Switching input source
Please operate input source change following the procedure mentioned below.
Setting method 1
You can change input source by OSD.
1)
Activate “Operation Button Guide
①
” by pressing any one of operation buttons
(A–C)
.
2) Press the “ MENU ” button.
3) Select “ INPUT SOURCE ” by using the “▲ ” button or the “▼ ” button and press the
“ OK ” button.
Secondly, select “ DisplayPort ” or “ DVI ” on OSD “INPUT SOURCE” and press the “ OK ”
button.
Note
When the monitor doesn’t receive input signals from two lines (DisplayPort
and DVI), even if you press the button, this function doesn’t work.
Setting method 2
You can make function buttons (F1 or F2) available to switch input signal.
By doing so, you can easily switch it by using a button.
The following steps tell you how to functionalize the “ F1 ” button.
1) Activate “Operation Button Guide ① ” by pressing any one of operation buttons
(A–C)
.
2) Press the “ MENU ” button.
3) Select “ FUNCTION ” on MENU 1/2 by using the “▲ ” button or the “▼ ” button and
press the “ OK ” button.
Secondly, select “ FUNCTION1 ” on OSD “FUNCTION” and press the “ OK ” button.
4) Select “ INPUT SOURCE ” on OSD “FUNCTION1” and press the “ OK ” button.
5) Activate “Operation Button Guide
①
” by pressing any one of operation buttons
(A–C)
.
6) Select “ DisplayPort ” or “ DVI ” on OSD “INPUT SOURCE” by pressing the “ F1 ” button
to switch input signal.
You can check the status of “ INPUT ” on OSD “CURRENT STATE”.
C U R R E N T S T A T E
L U M I N A N C E : 4 0 9
A M B L I G H T : 1 0 0 . 0 lx
C O L O R : 7 5 0 0 K
( x = 0 . 3 0 0 y = 0 . 3 1 5 )
I N P U T : D V I
C A L I B R A T I O N S E T T I N G
C O N F I G : 1
L U M I N A N C E : 4 1 0 / 0 . 6
G A MM A : D I C O M G S D F
C O L O R : 7 5 0 0 K
( x = 0 . 2 9 9 y = 0 . 3 1 5 )
5 M P
CURRENT STATE
Current input source