Step 9: Perform the Initial Configuration
An IP address is required to manage the TCX1000-RDM20 nodes. TCX1000-RDM20
nodes are DHCP-enabled by default; they automatically acquire an IP address from the
DHCP server when the unit is connected to the LAN. This IP address persists as long as
the node is connected to the LAN. To determine this DHCP assigned address; you can
query the DHCP server with the equipment’s MAC address or you can query the equipment
by using a CLI session.
NOTE:
NOTE: You must configure each TCX1000-RDM20 with a unique static
IP address. DHCP should be disabled.
Before opening a CLI session, set the following parameter values on the management
console or console server:
•
Baud rate—115,200
•
Flow control—None
•
Data—8
•
Parity—None
•
Stop bits—1
Once you have connected to the serial port (see
Connect the TCX1000-RDM20 to a
Management Console
), enter these commands from the CLI to configure the IP address
for the DCN 0 and DCN 1 ports:
1.
Enter the user ID:
superuser
2.
Enter the password:
<password>
15
Copyright © 2018, Juniper Networks, Inc.
Step 9: Perform the Initial Configuration