Juniper SRX5400, Руководство по оборудованию

Страница: 191 / 394

If you must insert the card into a bag by yourself, first lay the card horizontally on a flat,
stable surface, sheet metal side down. Orient the card with the faceplate facing you.
Carefully insert the card connector edge into the opening of the bag, and pull the bag
toward you to cover the card.
Never stack a card under or on top of any other component.
Related
Documentation
Routine Maintenance Procedures for the SRX5400 Services Gateway on page 211
•
•
Tools and Parts Required to Maintain the SRX5400 Services Gateway on page 211
•
SRX5400 Services Gateway Card Terminology
•
Holding an SRX5400 Services Gateway Card on page 162
Installing an SRX5400 Services Gateway SCB
To install the SCB (see Figure 80 on page 165 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Power off the services gateway.
3.
Carefully align the sides of the SCB with the guides inside the chassis.
4.
Slide the SCB into the chassis until you feel resistance, carefully ensuring that it is
correctly aligned.
Figure 80: Installing the SCB
g030333
5.
Grasp both ejector handles and rotate them simultaneously clockwise until the SCB
is fully seated.
6.
Place the ejector handles in the proper position, horizontally and toward the center
of the board.
165 Copyright © 2017, Juniper Networks, Inc.
Chapter 19: Installing Additional Components