Juniper SRX5400, Руководство по оборудованию

Страница: 203 / 394

Installing an SRX5400 Services Gateway Transceiver
Transceivers that are installed in an MIC or SPC. Transceivers are hot-insertable and
hot-removable. Removing a transceiver does not interrupt the functioning of the card,
but the removed transceiver no longer receives or transmits data.
CAUTION: If you face a problem running a Juniper Networks device that uses
a third-party optic or cable, the Juniper Networks Technical Assistance Center
(JTAC) can help you diagnose the source of the problem. Your JTAC engineer
might recommend that you check the third-party optic or cable and potentially
replace it with an equivalent Juniper Networks optic or cable that is qualified
for the device.
To install a transceiver:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to one of the ESD points on the chassis.
2.
Take each transceiver to be installed out of its electrostatic bag and identify the slot
on the component where it will be installed.
3.
Verify that each transceiver is covered by a rubber safety cap. If it is not, cover the
transceiver with a safety cap.
4.
Carefully align the transceiver with the slots in the component. The connectors should
face the component.
5.
Slide the transceiver until the connector is seated in the component slot. If you are
unable to fully insert the transceiver, make sure the connector is facing the right way.
6.
Close the ejector handle of the transceiver.
7.
Remove the rubber safety cap from the transceiver and the end of the cable. Insert
the cable into the transceiver.
8.
Verify that the status LEDs on the component faceplate indicate that the transceiver
is functioning correctly.
Related
Documentation
Preventing Electrostatic Discharge Damage to the SRX5400 Services Gateway
•
•
Removing an SRX5400 Services Gateway Transceiver on page 255
Installing the SRX5400 Services Gateway Craft Interface
To install the craft interface (see Figure 86 on page 178 ):
1.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
ESD points on the chassis.
2.
Grasp the craft interface with one hand and hold the bottom edge of the craft interface
with the other hand to support its weight.
177 Copyright © 2017, Juniper Networks, Inc.
Chapter 19: Installing Additional Components