Juniper SRX5400, Руководство по оборудованию

Страница: 240 / 394

•
To check the status of the SCB, issue the
show chassis environment cb
command. The
output is similar to the following:
user@host> show chassis environment cb
CB 0 status:
State Online Master
Temperature 40 degrees C / 104 degrees F
Power 1
1.2 V 1208 mV
1.5 V 1521 mV
1.8 V 1807 mV
2.5 V 2507 mV
3.3 V 3319 mV
5.0 V 5033 mV
12.0 V 12142 mV
1.25 V 1243 mV
3.3 V SM3 3312 mV
5 V RE 5059 mV
12 V RE 11968 mV
Power 2
11.3 V bias PEM 11253 mV
4.6 V bias MidPlane 4814 mV
11.3 V bias FPD 11234 mV
11.3 V bias POE 0 11176 mV
11.3 V bias POE 1 11292 mV
Bus Revision 42
FPGA Revision 1
To check the status of a specific SCB, issue the
show chassis environment cb node slot
command, for example,
show chassis environment cb node 0
.
For more information about using the CLI, see the CLI Explorer .
Related
Documentation
Routine Maintenance Procedures for the SRX5400 Services Gateway on page 211
•
•
Tools and Parts Required to Maintain the SRX5400 Services Gateway on page 211
•
Replacing the SRX5400 Services Gateway SCB on page 272
•
Replacing the SRX5400 Services Gateway Routing Engine on page 276
Maintaining SPCs on the SRX5400 Services Gateway
Purpose For optimum services gateway performance, verify the condition of the Services Processing
Cards (SPCs). The services gateway can have up to three FPCs (two SPCs) mounted
horizontally in the card cage at the front of the chassis. To maintain SPCs, perform the
following procedures regularly.
Action On a regular basis:
•
Check the LEDs on the craft interface corresponding to each SPC slot. The green LED
labeled
OK lights steadily when an SPC is functioning normally.
•
Check the OK/FAIL LED on the faceplate of each SPC. If the SPC detects a failure, it
sends an alarm message to the Routing Engine.
Copyright © 2017, Juniper Networks, Inc. 214
SRX5400 Services Gateway Hardware Guide