Juniper SRX5400, Руководство по оборудованию

Страница: 213 / 394

•
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 185
•
Connecting the SRX5400 Services Gateway to a Management Console or an Auxiliary
Device on page 184
•
Connecting the SRX5400 Services Gateway to a Network for Out-of-Band Management
on page 185
•
Connecting Network Cables to SRX5400 Services Gateway MICs on page 187
Connecting Network Cables to SRX5400 Services Gateway MICs
To connect the MICs to the network:
1.
Have ready a length of the type of cable used by the component.
2.
Remove the rubber safety plug from the cable connector port.
WARNING: Do not look directly into a fiber-optic transceiver or into the
ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable
connected to a transceiver emit laser light that can damage your eyes.
CAUTION: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing cable. The safety cap keeps the port clean and
prevents accidental exposure to laser light.
3.
Insert the cable connector into the cable connector port on the faceplate.
NOTE: The transceiver cages and optics on the components are industry
standard parts that have limited tactile feedback for insertion of optics
and fiber. You need to insert the optics and fiber firmly until the latch is
securely in place.
4.
Arrange the cable in the standard or extended cable manager to prevent it from
dislodging or developing stress points. Secure the cable so that it is not supporting its
own weight as it hangs to the floor. Place excess cable out of the way in a neatly coiled
loop. Placing fasteners on the loop helps to maintain its shape.
CAUTION: Avoid bending fiber-optic cable beyond its minimum bend
radius. An arc smaller than a few inches in diameter can damage the cable
and cause problems that are difficult to diagnose.
187 Copyright © 2017, Juniper Networks, Inc.
Chapter 21: Connecting the SRX5400 Services Gateway to External Devices