Juniper SRX4200, Руководство по оборудованию

Страница: 34 / 100

Table 16: Site Electrical Wiring Guidelines
Guideline Site Wiring Factor
To ensure that signaling functions optimally:
• Install wires correctly.
Improperly installed wires can emit radio interference.
• Do not exceed the recommended distances or pass wires between
buildings.
The potential for damage from lightning strikes increases if wires exceed
recommended distances or if wires pass between buildings.
• Shield all conductors.
The electromagnetic pulse (EMP) caused by lightning can damage
unshielded conductors and destroy electronic devices.
Signaling limitations
To reduce or eliminate the emission of RFI from your site wiring:
•
Use twisted-pair cable with a good distribution of grounding conductors.
• Use a high-quality twisted-pair cable with one ground conductor for
each data signal when applicable, if you must exceed the recommended
distances.
Radio frequency
interference (RFI)
Provide a properly grounded and shielded environment and use electrical
surge-suppression devices.
Strong sources of electromagnetic interference (EMI) can cause the
following damage:
• Destruction of the signal drivers and receivers in the device.
• Electrical hazards as a result of power surges conducted over the lines
into the equipment.
TIP: If your site is susceptible to problems with EMC, particularly from
lightning or radio transmitters, you might want to seek expert advice.
Electromagnetic
compatibility (EMC)
WARNING: Some ports are designed for use as intrabuilding interfaces only
Type 2 or Type 4 ports, the battery return connection is to be treated as an
Isolated DC return (that is, DC-I), as defined in GR-1089-CORE and require
isolation from the exposed OSP cabling. To comply with NEBS requirements
and protect against lightning surges and commercial power disturbances,
the intrabuilding port(s) of the device MUST NOT be metallically connected
to interfaces that connect to the OSP or its wiring. The intrabuilding port(s)
of the device is suitable for connection to intrabuilding or unexposed wiring
or cabling only. The addition of primary protectors is not sufficient protection
to connect these interfaces metallically to OSP wiring.
SRX4200 Services Gateway Physical Specifications
The SRX4200 Services Gateway chassis is a rigid sheet metal structure that houses all
the components.
Table 17 on page 35 lists the physical specifications of the SRX4200
Services Gateway chassis.
Copyright © 2019, Juniper Networks, Inc. 34
SRX4200 Services Gateway Hardware Guide