Juniper SRX4200, Руководство по оборудованию, Страница: 19 / 100

The services gateway must be connected to earth ground during normal operation.
SRX4200 Services Gateway Front Panel
Figure 1 on page 19 shows the front panel of the SRX4200 Services Gateway.
Figure 1: SRX4200 Services Gateway Front Panel
Table 3 on page 19 lists the components on the front panel of the services gateway.
Table 3: SRX4200 Services Gateway Components on the Front Panel
Description Component Number
Gigabit Ethernet port to connect to the device over the network. Management port 1
Two USB 2.0 ports that accept a USB storage device. USB ports 2
Two 1-Gigabit Ethernet/10-Gigabit Ethernet ports, CTL (control
port) and FAB (fabric port), to synchronize data and maintain
state information in a chassis cluster setup. These ports
support enhanced small form-factor pluggable (SFP+)
transceivers. HA ports 3
Eight 1-Gigabit Ethernet/10-Gigabit Ethernet SFP+ ports for
network traffic. SFP+ ports 4
Indicate component and system status at a glance. LEDs 5
Connects a laptop to the services gateway for CLI
management. The port uses an RJ-45 serial connection, is
configured as DTE, and supports the RS-232 (EIA-232)
standard. Console port 6
Returns the services gateway to the factory-default
configuration. Reset button 7
Chassis Status LEDs
Figure 2 on page 20 shows the front panel LEDs and Table 4 on page 20 describes the
LEDs.
19 Copyright © 2019, Juniper Networks, Inc.
Chapter 1: Overview