Juniper NFX150, Руководство по оборудованию

Страница: 87 / 152

•
Configuring the LTE Expansion Module on page 89
• Configuring the LTE Expansion Module for Primary Mode on page 89
• Configuring the LTE Expansion Module for Dial-on-Demand Mode on page 91
•
Configuring the LTE Expansion Module for Backup Mode on page 93
Installing the Expansion Module
NOTE: You can install only one expansion module on the NFX150-S1 devices.
The expansion module must be installed in the first slot, which is present
beside the chassis LEDs.
To install the expansion module such as NFX-EM-6T2SFP in an NFX150 device:
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
the strap to the grounding point on the back of the device.
2.
Power off the device using the following command:
request system power-off
3.
Remove both the blank modules installed on the device:
• Loosen the screws on the faceplate of the blank module.
•
Grasp the screws on each side and remove the blank module.
4.
Remove the expansion module from the electrostatic bag.
5.
Grasp the screws on each side of the module faceplate and align the notches in the
connector at the rear of the module with the notches in the module slot in the device.
6.
Slide the module in until it lodges firmly in the services gateway.
7.
Using a 1/8-in. (3-mm) flat-blade (–) screwdriver, tighten the screws on each side of
the module faceplate.
8.
Power on the device.
Installing the LTE Expansion Module
NOTE: You can install only one expansion module on the NFX150-S1 devices.
The expansion module must be installed in the first slot, which is present
beside the chassis LEDs.
87 Copyright © 2018, Juniper Networks, Inc.
Chapter 3: Initial Installation and Configuration