Juniper NFX150, Руководство по оборудованию

Страница: 103 / 152

To connect a fiber-optic cable to an optical transceiver installed in an NFX150 device:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
WARNING: Do not stare into the laser beam or view it directly with optical
instruments even if the interface has been disabled.
1.
If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap.
Save the cap.
2.
If the optical transceiver is covered by a rubber safety cap, remove the cap. Save the
cap.
3.
Insert the cable connector into the optical transceiver (see Figure 38 on page 83 ).
4.
Secure the cables so that they are not supporting their own weight. Place excess cable
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. Bending the cables beyond their minimum bend radius can damage
the cables and cause problems that are difficult to diagnose.
CAUTION: Do not let fiber-optic cables hang free from the connector. Do
not allow fastened loops of cables to dangle, which stresses the cables
at the fastening point.
Figure 46: Inserting a Fiber-Optic Cable into a Transceiver on an NFX150-S1 Device
g100011
103 Copyright © 2018, Juniper Networks, Inc.
Chapter 4: Maintaining Components