Juniper JUNOSE 11.2.X IP SERVICES, Руководство по настройке

Страница: 217 / 356

Defining an ANCP Neighbor
The L2C Neighbor Configuration mode enables you to define an ANCP neighbor by
specifying a neighbor ID and the maximum number of branches that the neighbor can
have.
id
•
Use to specify the ANCP neighbor ID in the L2C Neighbor Configuration
(config-l2c-neighbor) mode.
•
Example
host1(config-l2c)# neighbor
host1(config-l2c-neighbor)# id 1234.5678.9123
•
Use the no version to remove the neighbor ID.
•
See id.
max-branches
•
Use to specify the maximum number of branches the ANCP neighbor can have.
•
Example
host1(config-l2c-neighbor)# max-branches 50
•
Use the no version to return the maximum number of branches to its default value,
unlimited branches.
•
See max-branches.
Limiting Discovery Table Entries
You use the max-discovery-table-entries command to specify the maximum number
of discovery table entries that a neighbor can have.
Using this command to change the maximum number of entries when an already greater
number of current entries exists in the discovery table does not remove any existing
entries. Instead, future entries are prevented. For example, if the current table contains
5000 entries, and you specify a maximum of 4000 entries, the software does not remove
any existing entries from the table. The software prevents any new entries until the
number of table entries falls below the specified maximum.
max-discovery-table-entries
•
Use to specify the maximum number of discovery table entries a neighbor can have in
the range 1–64000 entries.
•
Example
host1(l2c-neighbor)# max-discovery-table-entries 4000
•
Use the no version to return the maximum number of discovery table entries to its
default value, 10,000 entries.
•
See max-discovery-table-entries.
191 Copyright © 2010, Juniper Networks, Inc.
Chapter 7: Configuring ANCP