Juniper JUNOS 10.2, Руководство по модернизации

Страница: 70 / 96

[edit]
root#
set system domain-name domain-name
4.
Configure the IP address and prefix length for the router Ethernet interface.
■
For all routers except the TX Matrix Plus router and T1600 routers in a routing
matrix:
[edit]
root@#
set interfaces fxp0 unit 0 family inet address address / prefix-length
■
For TX Matrix Plus and T1600 routers in a routing matrix only:
[edit]
root@#
set interfaces em0 unit 0 family inet address
address
/
prefix-length
To use em0 as an out-of-band management Ethernet interface, you must
configure its logical port, em0.0 , with a valid IP address.
■
For a T1600 standalone router (not connected to a TX Matrix Plus router
and not in a routing matrix):
[edit]
root@#
set interfaces fxp0 unit 0 family inet address address / prefix-length
5.
Configure the IP address of a backup router. The backup router is used while the
local router is booting and if the routing process fails to start. Once the routing
process starts, the backup router address is removed from the local routing and
forwarding tables. For more information on the backup router, see the
JUNOS
System Basics Configuration Guide .
[edit]
root#
set system backup-router address
6.
(Optional) Configure the static routes to remote subnets with access to the
management port. Access to the management port is limited to the local subnet.
To access the management port from a remote subnet, you need to add a static
route to that subnet within the routing table. For more information on static
routes, see the
JUNOS System Basics Configuration Guide .
[edit]
root#
set routing-options static route
remote-subnet
next-hop
destination-IP
retain no-readvertise
7.
Configure telnet service at the
[edit system services]
hierarchy level.
[edit]
root#
set system services telnet
48 ■
Add the Management Console to the Network
JUNOS Release 10.2 Software Installation and Upgrade Guide