Juniper JUNOS 10.2, Руководство по модернизации

Страница: 58 / 96

Installing Software on the Backup Routing Engine
Once the router is ready, you first install the software on the backup Routing Engine.
This enables the primary Routing Engine to continue operations, minimizing the
disruption to your network.
1.
Log in to the backup Routing Engine’s console:
For more information on logging in to the Routing Engine through the console
port, see the administration manual for your particular router.
2.
Install the new software package using the
request system software add
command:
user@host> request system software add validate
/var/tmp/jinstall-9.2R1.8–domestic-signed.tgz
For more information on the request system software add command, see the
JUNOS System Basics and Services Command Reference .
3.
Reboot the router to start the new software using the
request system reboot
command:
user@host> request system reboot
Reboot the system? [yes, no] (no) yes
NOTE: You must reboot the device to load the new installation of the JUNOS Software
on the router.
To abort the installation, do not reboot your device, instead, finish the installation
and then issue the
request system software delete jinstall
command. This is your last
chance to stop the installation.
All the software is loaded when you reboot the device. Installation can take
between 5 and 10 minutes. The router then reboots from the boot device on
which the software was just installed. When the reboot is complete, the router
displays the login prompt.
While the software is being upgraded, the Routing Engine on which you are
performing the installation is not routing traffic.
4.
Log in and issue the
show version
command to verify the version of the software
installed.
5.
(Optional) Add the
jweb
package using the
request system software add
command.
Before you can add this package, you must first download the software as you
did the installation package. For more information on downloading the
jweb
package, see “Downloading Software” on page 30.
The
jweb
installation module adds a router management graphical user interface
that you can use to view and configure your router. For more information about
the
jweb
package, see “Installation Modules” on page 7.
36 ■
Installing Software on the Backup Routing Engine
JUNOS Release 10.2 Software Installation and Upgrade Guide