Juniper CTP1000 Series, Руководство по оборудованию

Страница: 14 / 88

•
Power LED—Green when power is connected and the power switch is set to the ON
position.
• HDD LED—Red when the drive is in use.
•
Front power switch—Set to
ON
position when
1
is briefly pressed. Set to
OFF
when
1
is
pressed for four or more seconds.
•
Removable flash drive—The device must be powered off when you insert or remove
the flash drive.
The rear panel comprises the following components (see Figure 2 on page 4 ):
Figure 2: CTP1002 Chassis (Rear View)
External Reference Input
BNC or DB=9
SE-0/0 SE-0/1
Ethernet
USB
Console
g015351
• Power input from the external 12-VDC power supply.
• Port 0 and port 1 DB-25 connectors—DB-25 connectors are used for terminating EIA530,
RS-232, V.35, 4WTO, and T1 circuits.
The DB-25 port connector pinout is the same as the quad cables used on the larger
CTP platforms. See
“CTP1000 Interface Module 100-to-25-Pin Cable Pinouts” on
page 25 to find pinout information for this connector.
• COM 2
console connection—Provides an asynchronous TTY connection for local
configuration of the CTP platform. See “CTP1000 Console Cable Pinouts” on page 29
to find pinout information for this connector.
• Fast Ethernet connector—Provides the 100-Mbps Ethernet connection to the IP network
by means of a local Ethernet switch or router.
•
USB port.
Related
Documentation
CTP1004 Platform on page 5
•
•
CTP1012 Platform on page 7
Copyright © 2015, Juniper Networks, Inc. 4
CTP1000 Series Hardware Guide